Which holes and slots do I use on Endless 100?

To center the Endless 100 Frame on the FR1/FR3 boot (or any boot with 7-hole mounting), align the rear mounting slot with the center hole in the heel mounting plate.  The front slot should align with the most forward hole in the mounting plate under the toes.

• Recommended mounting: 180 mm
  • Frame will have a centered alignment 
  • May not be compatible with all boots - ask if you don't see your skate listed
  • Boot must have fully threaded 3-hole or 7-hole mounting plates
  • Compatible boots: FR1, FR2 (2016 and newer), FR3, Seba Trix 2, Seba High Light (Carbon, V2), Seba iGoR, Flying Eagle F6/F7, Flying Eagle Drift (1,2), Oxelo MF 500, Micro Delta F (carbon cuff); 7-hole mounts
• Alternate mounting: 165 mm
  • Frame will have offset towards the rear of the boot (rear bias)
  • Boots may have 2-hole or 5-hole mounting plates
  • Compatible boots: Rollerblade Twister Edge, Rollerblade Maxxum Edge, Rollerblade RB 80/110/DA,FRW, FRX, FR2 (2015), Seba GT, Seba Trix (5-hole), Powerslide Hardcore Evo, Rollerblade Metroblade, Micro MT Plus, Micro Delta (plastic cuff); 5-hole mounts; UFS boots (including FR Skates UFR)

For reference this is what a 7-hole mounting plate looks like: